turt18 turt19 turt20 turt21

 

Today I went with a combination of medallion and shadow box ( the shadow box being the flower inside the turtle . I used 20 gauge sterling silver for that . The reason for not using 18 gauge was that I ran out ,lol :)    But that worked out in the end as I added an extra circle .

turt turt1

I cut out a large circle 1 1/4 inch in diameter with the help of my disc cutter. If you don’t have one you can always cut out a circle by hand . I invested in a disc cutter after cutting out discs right and left and wasting a lot of time doing it .  I drew the turtle onto paper that has a sticky back( uline label paper ) and stuck it to the sheet of metal . If you only have regular paper either glue it to the metal or use rubber cement ( rubber cement is easier to peel off after you are done cutting  I cut out the turtle with my 6 inch jewelers hand saw and some 1/0 saw blades ( I go with the ones from Germany – being a bit patriotic )

turt2 turt3 turt4

 

Punch or drill a feeding hole inside your flower and feed your saw blade through . Start cutting out the flower .  Clean your metal with some sand paper to make it easier to solder

turt5 turt6

Make sure everything fits well together . I did not like how the turtle and the circle looked so I decided to add a 1 inch circle in between the turtle and the 1 1/4 inch circle . Next step is soldering .

turt7 turt8 turt9 turt10 turt11 turt12

Flux the back of the turtle and the 1 inch circle and add your solder ( sheet , wire or stick solder ) . Start heating the metal with your torch using slow circular motions so that the flame does not hit just one spot . Use a third hand to keep things from slipping while you solder. Quench and repeat with adding the turtle to the 1 inch circle  I recommend first soldering both circles together and then to add the turtle . Last picture Is the piece all soldered together after quenching it in water. To clean it put it in your pickle solution .

turt13 turt14 turt15 turt16 turt17

 

After your sterling turns white in the Pickle solution take it out with copper tongues and rinse with water and dry . Pre polish really quick with your flex shaft and start adding some texture ( anything goes – screw drivers , nails ect . )  Polish again and then add patina  Liver of sulfur gives the best result . Polish one last time taking care that you leave some lack low lights so that the texture and the turtle pop . Add a ail or a jump ring and put it on a chain :) finished is your turtle pendant . As always I hope you enjoyed my little tutorial . I am always open to questions and will help where I can . :)

 

you can visit my store at www.nicilaskin.etsy.com if you are interested in buying some of my pieces

 

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s